The RTP Pager can receive G.711-encoded audio data from up to four multicast groups (i.e., combinations of IP addresses and ports).
The received data will be played on the camera speaker. As a precondition, the camera must have a speaker connected that has to be activated. (see Speaker and Microphone dialog).
Note that the received audio data will not be mixed. If data are received from different multicast groups, the first group to send its data will be played on the speaker. If this group stops the transmission, the next group will be played automatically.
Note that in one multicast group, only one sender may send data at any given time! If several services send audio data at the same time to the same multicast group, the audio data cannot be played properly.
Activates the RTP Multicast Pager ("RTP Pager"). Changes require rebooting the camera.
Every one of the four streams has its own configuration section with the corresponding parameters Multicast IP and Port.
IP address of the multicast group sending the audio data. The IP address must be a valid multicast IP in the range from
Network port used to receive the multicast data. The port has to be in the range from
65535. A value of
0 will deactivate the receiver.
Click on the Set button to activate your settings and to save them until the next reboot of the camera.
Click on the Factory button to load the factory defaults for this dialog (this button may not be present in all dialogs).
Click on the Restore button to undo your most recent changes that have not been stored in the camera permanently.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.